On a kayak your phone does three jobs at once: navigation, photos and a way to call for help if something happens. The trouble is that all three need the phone within reach, not in a backpack. This guide explains which kayak mounts actually hold, how height changes the shot you film, and which of our kayaks come with factory tracks, so you will not need to drill anything.
Why a phone on a kayak without a mount is a lost phone
The most common misconception: if the phone is waterproof, nothing will happen to it. Waterproof means the phone will survive a brief dunk. It does not mean the phone floats. A phone that slips out of your hand sinks in a lake within seconds, and at five meters deep you will not find it even with a fish finder.
The second problem is that phones fall out on a kayak not because of waves but because of movement. The critical moment is almost always the same: one hand holds the rod or paddle, the other tries to take the phone out of a pocket or put it back. That is exactly what one-handed mounts are made for.
YakAttack RotoGrip Phone Holder Pro, priced at 99 EUR, solves exactly that. The phone snaps in between two rubber wheels in one motion, with no clips or straps. The wheels grip the phone by its edges and do not cover the screen. It fits phones 7.0 to 9.2 cm wide and 7.7 to 15.9 mm thick, with or without a case. It comes with a 122 cm steel safety cable, which is the detail that separates a lost phone from one dangling over the side.
Mount types: what holds and what does not
Tracks, also called track mounts
A track is an aluminum or plastic profile on the kayak deck that a mount base slides into and locks down. It is the strongest and most flexible option, because you can slide the mount along the whole track and remove it without tools. Most modern fishing kayaks have at least two tracks next to the seat.
In the YakAttack system the base is called LockNLoad and has three modes: locked, adjust and release. You can find the bases here: LockNLoad rail base and Complete LockNLoad mounting base, priced from 20 to 29 EUR.
StarPort and round bases
The Railblaza system works differently. It uses a round base StarPort, which screws onto a flat surface and accepts any Railblaza accessory. The advantage is that one base works for a rod holder, a camera boom, a fish finder and a flag, and you can swap accessories in seconds. The downside is that the base sits in a fixed spot, so you need to think about its position before screwing it down.
If your kayak or aluminum boat has no track and you would rather not drill, there are in-between solutions: TracWedge StarPort lets you attach a base to the gunwale with a screwdriver, no drilling.
Suction cups
Suction cups are not suitable for kayaks, for three specific reasons. First, a kayak deck is textured or matte, while a suction cup needs a perfectly smooth surface. Second, a suction cup holds through a pressure difference that changes with air temperature: a mount stuck on in the morning warms up by midday and lets go. Third, a kayak always has water and sand in it, and a grain of sand under the edge of a suction cup means a slow air leak. A suction cup holds perfectly until it stops holding, and that always happens without warning.
Camera mounts: height decides what you see in the shot
Camera mounts differ not in quality but in height. Height determines what you see in the footage, and it is the only parameter worth choosing deliberately.
- 14 cm, YakAttack Articulating. A shot from deck level. You see your hands, the rod and the water in front of the kayak. Landing a fish and casting a lure look good, but the angler is barely in the frame. The mount is made for cameras up to 1.4 kg and does not get in the way of paddling.
- 29 cm, PanFish Portrait Pro. The camera sits slightly above the deck. The frame takes in the crate, the rod holders and part of the angler. A good compromise for close shots, and it rotates 360 degrees with one hand.
- 84 cm, PanFish Pro. The camera is above head height when seated. The frame shows the angler, the whole deck and the water around. This is the standard choice if you want footage that shows what is happening on the kayak.
- 131 cm, BoomStick Pro. From this height the frame takes in the whole kayak with the angler and part of the surroundings. The view looks like it was filmed from a boat alongside. Price 179 EUR.
All PanFish series mounts share the same practical feature: you can turn the camera with one hand without loosening a single screw, so a pan shot comes out smooth rather than jerky. The kits include both a 1/4-inch 20-thread ball for a regular camera and a GoPro adapter, so you do not need to buy anything extra. The aluminum construction floats, which means a dropped mount with the camera stays on the surface.
In the Railblaza system the equivalent is the Camera Boom 600 R-Lock with a 750 mm boom and four moving joints. The difference is fundamental: PanFish lifts the camera up, while the Camera Boom extends it out to the side of the kayak, so you see yourself from the outside. It mounts on any StarPort and weighs 0.4 kg.
Camera angle for fishing: what you will actually see
Before buying, it is worth knowing what to expect from each position.
- Camera at the front, pointing at the angler. The best option for hooksets and landing fish. The drawback: a kayak heading into the sun gives you a silhouette instead of a face, so morning and evening footage is often unusable.
- Camera behind you, pointing forward. You see the whole deck and the water in front of the kayak. This is the position that best shows your casting and where the lure went. The angler's face is not visible.
- Camera to the side, on a boom. The only position that shows the kayak from the outside. It needs the most space and is the most likely to snag your line.
- Camera low, right at the water. The water surface looks far more dramatic and the fish looks bigger in the frame. But any splash on the lens ruins the rest of the recording, and you will not have time to wipe it.
A practical tip: a camera mount and a rod holder on the same side track almost always end with the line catching on the camera. Mount the camera on the opposite side from the one you cast to.
Compatibility: which kayaks have factory tracks
This is the most important question before buying a mount, because it determines whether you will need to drill. According to our product descriptions, the following models have factory tracks.
- NuCanoe Flint and NuCanoe U10 with TopLoad aluminum tracks. In the NuCanoe system, LockNLoad accessories fit directly, with no adapter.
- Wilderness Systems A.T.A.K. 120 with GearTrac tracks.
- Bonafide models with GearTrac tracks, for example the SS127 and PWR129.
- Galaxy Kayaks Wildcat with StarPort-type bases and Galaxy Kayaks Supernova FX with tracks.
If your kayak has no track, you can add one. We described how to do it properly accessory mounting guide. For a fish finder screen there is a separate solution: LockNLoad fish finder screen mount, and a broader explanation of fish finders is in our fish finder guide.
Measuring board and a photo with your fish
If you keep your phone handy to photograph your catch, it is worth adding a measuring board next to the mount. YakAttack Metric LeaderBoard is a 71 cm board with 0.5 cm markings, a DoubleTake mirror at the bump board edge and a floating EVA foam base. The mirror shows the gap between the fish's nose and the edge, so there is no argument about length in the photo. For tournaments it is mandatory gear, and for a regular angler it is the only way to have real numbers rather than memories.
The board mounts on a track in two ways. The straight option is the LeaderBoard RotoGrip 2 Pack, where the two holders mount on the same track section at least 15 cm apart. The offset option is the LeaderBoard DoubleHeader Track Mount, which is attached at one point and pulls the board 8.9 cm away from the rail so that it does not block adjacent openings. Price from 39.99 to 47.99 EUR. Both options hold the board in such a way that it only comes loose in one direction, so it does not accidentally fall into the water.
What to choose
If you only need a phone mount. The RotoGrip Phone Holder Pro and a track base if your kayak does not have a track yet. With the safety cable, it is a complete solution and you need nothing else.
If you film occasionally. The Articulating mount with a GoPro adapter. The cheapest option in the series, it does not get in the way of paddling and suits action cameras.
If you film all the time. The PanFish Pro. 84 cm of height is the point at which both the angler and the kayak appear in the frame, and one-handed rotation means you can change the shot without putting down the rod.
If you create content. The BoomStick Pro or the Camera Boom 600. One lifts the camera up, the other pulls it out to the side, and together they give you two different angles of the same footage.
Stock levels change, and you can always see an item's exact availability on the product page. Some YakAttack products are made to order, so it is worth confirming the lead time before the season. The full range is on the YakAttack brand page and in the accessories category. If you are just starting to set up a kayak, begin with the rigging guide, and we covered anchoring in the anchoring article.
Recommended products
The most popular products in this category





